In the section Tricks and Tips you will find the solution to this problem explained in detail. If, after installation, you verify that the computer detects the device but displays an error message with code 10 (you will see it in the device manager, in the COM port where it was detected), then there is a problem of this type. In Windows 8, 8.1 and 10 there is a problem with some PL2303 chips and driver. As always, I would appreciate any information about this, you can send me an email. I imagine that for linux there will be drivers and aplications and for iOS will be more complicated.

I don't know if it can be used on linux or iOs systems. In the SOFTWARE section you will find more information about this program, including its installation and configuration. one click: download drivers for Windows 11, 10, 8.1, 8, and 7 (32-bit/64-bit). Softwares Compatible: FORScan, Elmconfig, FF2 and FoCCCus Supported operating systems: All Windows versions - XP, Vista, 7, 8, 10 Supports all OBD 2 protocols.

I always recommend the ScanMaster application for Windows because I consider it the most complete, intuitive and easy. VIA ELM327 USB interface Windows drivers can help you to fix VIA ELM327 USB. Once installed the required driver the computer will recognize the device without problems and we can use it with any compatible program. If you do not have any decompressors you can install WinZip or WinRar. I would start with the CH340 and, if it did not work, I would continue with the PL2303.

A little further down, in the download area of this page, you will find several USB controllers to test. The links below allow you to download the OBD Auto Doctor car diagnostics sofware.

Elm 327 windows 10 driver